Header

Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

Version 1 Next »

An Error Handling Flag is a pre-defined behaviour of a test case or a test suite execution when any step fails. 

You can set Error Handling Flags at two levels:

  • Task Level: To set flags for tasks in the Test Case Editor screen
  • Test Case Level: To set flags for test cases in the Test Suite screen.

By default, an Error Handling Flag is set to Continue. To change the flag for a task or a test case, double-click its flag and select the flag you want to apply.

Points to Know

  • Error Handling Flags are applied only for error conditions and not for defects. For example, execution status of following step is "Defect" and not "Error".
    CompareString "a" "ab" "true"
  • Error Handling Flags do not apply to the invalid IF/ELSE IF steps.

Error Handling Flag Settings in a Test Case

In a test case, you can set the Task Level error handling flags for all the tasks to define the execution behaviour of the test case in a suite execution and even in a dry run. 

The following table shows how flags can be set in tasks of a test case. 

IconFlag NameDescription

ExitTCIteration

If any task step fails, QAS skips executing the current test case iteration and starts executing the next iteration. If there is only one TC iteration, then the test case execution stops.

ExitTaskIf any step of this task fails, QAS skips all the remaining steps of the current task, and starts executing the next step or task.

Continue

If any step of this task fails, QAS does not exit and continues executing the remaining steps and tasks.

Error Handling Flag Settings in a Test Suite

In a test suite, you can set the Test Case Level error handling flags for all the tasks to define the execution behaviour of the test suite. 
The following table shows how flags can be set in test cases of a test suite. 

IconFlag NameDescription
ExitTCIterationIf any step fails, QAS skips executing the current test case iteration and starts executing the next iteration. If there is only one TC iteration, then the QAS starts executing the next test case.
ExitSuiteIf any step fails, QAS stops executing the whole suite.
ContinueIf any step fails, QAS does not exit and continues executing the remaining steps and tasks.

The following table shows the suite execution behaviour when a flag is set for task and also for its its test case. 


Flag for Task on Test Case Screen

Flag for Test Case on

Suite Screen

Screen Settings Considered

Result

Continue

Continue

TC

Continue

ExitTask

Continue

TC

ExitTask

ExitTCIteration

Continue

TC

ExitTCIteration

Continue

ExitTCIteration

Suite

ExitTCIteration

ExitTask

ExitTCIteration

Suite

ExitTCIteration

ExitTCIteration

ExitTCIteration

Suite

ExitTCIteration

Continue

ExitSuite

Suite

ExitSuite

ExitTask

ExitSuite

Suite

ExitSuite

ExitTCIteration

ExitSuite

Suite

ExitSuite

  • No labels